meta data for this page
  •  

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
en:controller:setup [2024/04/01 06:19]
vasilisk 		en:controller:setup [2025/03/19 09:36] (current)
dmitry [Connection diagram]
Line 47: Line 47:
 When the power is turned on for the first time, the controller will start automatically. To enable/disable the controller, you must connect an external switch according to the diagram or configure the button located on the back of the On-board computer in the menu **Devices**  > **Controller**  > **Extra parameters**  > **Disable button**. When the power is turned on for the first time, the controller will start automatically. To enable/disable the controller, you must connect an external switch according to the diagram or configure the button located on the back of the On-board computer in the menu **Devices**  > **Controller**  > **Extra parameters**  > **Disable button**.
  
-You can find the wiring diagrams of the other devices on this [[https://drive.google.com/file/d/175f4Cv4QuhjYu4UIwU951rA5HNJUEr5k/view?usp=drive_link|link]]. By default, all peripherals (throttle, brake, switches, etc.) are connected into ports located on the backside of **[[:en:display:start|On-board computer]]** . To access the ports, you need to unscrew five screws and remove the plastic cover. For connection, use PHD 2.0 connectors and crimp pins, which are included in the kit. If you do not have a crimping tool such as Crimper SN-2549, you must order "Crimped wires for display". The On-board computer is connected to the controller with one CAN-wire 1.2 meters long, which is included in the controller kit. Be careful, the CAN-wire from the Controller is connected to the **SYSTEM**  connector on the backside of the On-board computer.+You can find the wiring diagrams for 6F,12F,24F, On-board computer and uLigt on this [[https://drive.google.com/file/d/175f4Cv4QuhjYu4UIwU951rA5HNJUEr5k/view?usp=drive_link|link]], wiring diagram for P24F and Encoder board [[https://docs.nucular.tech/doku.php?id=en:controller:schematic|here]]. By default, all peripherals (throttle, brake, switches, etc.) are connected into ports located on the backside of **[[:en:display:start|On-board computer]]** . To access the ports, you need to unscrew five screws and remove the plastic cover. For connection, use PHD 2.0 connectors and crimp pins, which are included in the kit. If you do not have a crimping tool such as Crimper SN-2549, you must order "Crimped wires for display". The On-board computer is connected to the controller with one CAN-wire 1.2 meters long, which is included in the controller kit. Be careful, the CAN-wire from the Controller is connected to the **SYSTEM**  connector on the backside of the On-board computer.
  
 If you want to connect peripherals directly to the Controller, you need to order "Control-side inputs", in the diagram below this switching option is designated as "Alternative connection". You can also use a mixed connection, for example, connect the throttle lever to the On-board computer, and the brake lever to the Controller. \\ If you want to connect peripherals directly to the Controller, you need to order "Control-side inputs", in the diagram below this switching option is designated as "Alternative connection". You can also use a mixed connection, for example, connect the throttle lever to the On-board computer, and the brake lever to the Controller. \\