meta data for this page
Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
en:controller:diagnostics [2024/03/14 04:23] vasilisk |
en:controller:diagnostics [2024/03/14 04:31] vasilisk [Writing a log to file] |
||
---|---|---|---|
Line 39: | Line 39: | ||
In the **Controller ** > **Logger** | In the **Controller ** > **Logger** | ||
For this you will need microSD card or bluetooth dongle with app. | For this you will need microSD card or bluetooth dongle with app. | ||
- | 1) Insert microSD into display OR run app and connect to controller. | + | - Insert microSD into display OR run app and connect to controller. |
- | 2) Go to **Controller ** > **Logger** and select **Start logging** = **On**. | + | |
- | By default logging will be started when bike moves. | + | |
- | 4) Reproduce problem or make full power acceleration to the top speed. | + | |
- | 5) Stop vehicle. | + | |
- | 6) Go to **Controller ** > **Logger** and select **Stop logging** = **On**. | + | |
- | 7) (Optionally) Repeat writing more logs if problem did not occur. Go to step 2. | + | |
- | 8) Copy files from microSD card or files from phone and send all NClogX.csv to support. | + | |
- | + | \\ | |
+ | Note: Log rates faster than 10ms (e.g., 1ms and less) may result in gaps in logger data due to the limits of the CAN bus speed. You can select 'Mode = Max rate' to attempt recording at the maximum possible data rate. |