meta data for this page
  •  

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision 		Previous revision
Last revision Both sides next revision
en:controller:diagnostics [2024/03/14 04:24]
vasilisk [Writing a log to file] 		en:controller:diagnostics [2024/03/14 04:31]
vasilisk [Writing a log to file]
Line 38: Line 38:
 ===== Writing a log to file ===== ===== Writing a log to file =====
 In the **Controller **  > **Logger**  menu section, you can enable and configure the data logging during the operation of the Controller. Full documentation about logger [[en:controller:setup#logger|here]].\\ In the **Controller **  > **Logger**  menu section, you can enable and configure the data logging during the operation of the Controller. Full documentation about logger [[en:controller:setup#logger|here]].\\
-For this you will need microSD card or bluetooth dongle with app.\\ +For this you will need microSD card or bluetooth dongle with app. 
-1) Insert microSD into display OR run app and connect to controller.\\ +  - Insert microSD into display OR run app and connect to controller. 
-2) Go to **Controller **  > **Logger** and select **Start logging** = **On**. \\ +  - Go to **Controller **  > **Logger** and select **Start logging** = **On**.  
-By default logging will be started when bike moves.\\ +  - By default logging will be started when bike moves.\\ 
-4) Reproduce problem or make full power acceleration to the top speed.\\ +  - Reproduce problem or make full power acceleration to the top speed. 
-5) Stop vehicle.\\ +  - Stop vehicle. 
-6) Go to **Controller **  > **Logger** and select **Stop logging** = **On**. \\ +  - Go to **Controller **  > **Logger** and select **Stop logging** = **On**.  
-7) (Optionally) Repeat writing more logs if problem did not occur. Go to step 2.\\ +  - (Optionally) Repeat writing more logs if problem did not occur. Go to step 2. 
-8) Copy files from microSD card or files from phone and send all NClogX.csv to support.\\ +  - Copy files from microSD card or files from phone and send all NClogX.csv to support. 
- +\\ 
 +Note: Log rates faster than 10ms (e.g., 1ms and less) may result in gaps in logger data due to the limits of the CAN bus speed. You can select 'Mode = Max rate' to attempt recording at the maximum possible data rate.