meta data for this page
Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
en:controller:diagnostics [2024/03/14 04:25] vasilisk [Writing a log to file] |
en:controller:diagnostics [2024/03/14 04:31] vasilisk [Writing a log to file] |
||
---|---|---|---|
Line 42: | Line 42: | ||
- Go to **Controller ** > **Logger** and select **Start logging** = **On**. | - Go to **Controller ** > **Logger** and select **Start logging** = **On**. | ||
- By default logging will be started when bike moves.\\ | - By default logging will be started when bike moves.\\ | ||
- | Reproduce problem or make full power acceleration to the top speed. | + | - Reproduce problem or make full power acceleration to the top speed. |
- Stop vehicle. | - Stop vehicle. | ||
- Go to **Controller ** > **Logger** and select **Stop logging** = **On**. | - Go to **Controller ** > **Logger** and select **Stop logging** = **On**. | ||
- (Optionally) Repeat writing more logs if problem did not occur. Go to step 2. | - (Optionally) Repeat writing more logs if problem did not occur. Go to step 2. | ||
- Copy files from microSD card or files from phone and send all NClogX.csv to support. | - Copy files from microSD card or files from phone and send all NClogX.csv to support. | ||
- | + | \\ | |
+ | Note: Log rates faster than 10ms (e.g., 1ms and less) may result in gaps in logger data due to the limits of the CAN bus speed. You can select 'Mode = Max rate' to attempt recording at the maximum possible data rate. |