Differences

This shows you the differences between two versions of the page.

--- en:controller:light-fan-pwm [2020/10/05 13:05]
oleg
+++ en:controller:light-fan-pwm [2020/10/08 16:08]
vasilisk
@@ Line 1: / Line 1: @@
 ~~Title: Fan and Light Control~~
+====== Fan and Light Control ======
 It is possible to connect stoplight or fan to controller port P1/P2. Configuration described in [[:en:controller:setup|Controller setup]].\\
@@ Line 6: / Line 8: @@
 You can connect small power light directly to controller with this scheme, 1khz operation is enough:
-{{http://nucularelectronics.wdfiles.com/local--files/en:controller-light-fan-pwm/non-isolated pwm.png?nolink&|non-isolated%20pwm.png}}
+{{:en:controller:mosfet-lamp.png?nolink&438x325|non-isolated%20pwm.png}}
 If you are using something more powerful, isolated scheme recommended, you can also buy this kind of boards on aliexpress (Mosfet Optocoupler Isolation Driver):
-{{http://nucularelectronics.wdfiles.com/local--files/en:controller-light-fan-pwm/isolated pwm.png?nolink&|isolated%20pwm.png}}
+{{:en:controller:opto-mosfet.png?nolink&717x532|isolated%20pwm.png}}
 Fan control requires 4-wire Fan, or you can try to use same scheme as for light. 20khz is default, but you can try any lower. 4-wire fan scheme:\\
-{{http://nucularelectronics.wdfiles.com/local--files/en:controller-light-fan-pwm/fan 4-wire.png?nolink&|fan%204-wire.png}}
+{{:en:controller:fan.png?nolink&381x199|fan%204-wire.png}}