meta data for this page
  •  

This is an old revision of the document!


It is possible to connect stoplight or fan to controller port P1/P2. Configuration described in Controller setup
Please note that controller outputs are open-drain 5V max, 220R resistor on the line. Don't use controller logic ground for loads more than 0.5A, use power ground instead. System (CAN) cable uses power ground.

You can connect small power light directly to controller with this scheme, 1khz operation is enough:

non-isolated%20pwm.png

If you are using something more powerful, isolated scheme recommended, you can also buy this kind of boards on aliexpress (Mosfet Optocoupler Isolation Driver):

isolated%20pwm.png

Fan control requires 4-wire Fan, or you can try to use same scheme as for light. 20khz is default, but you can try any lower. 4-wire fan scheme:
fan%204-wire.png