meta data for this page
Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | |||
en:controller:light-fan-pwm [2020/10/08 16:08] vasilisk |
en:controller:light-fan-pwm [2022/04/06 12:34] (current) vasilisk |
||
---|---|---|---|
Line 3: | Line 3: | ||
====== Fan and Light Control ====== | ====== Fan and Light Control ====== | ||
- | It is possible to connect stoplight or fan to controller port P1/P2. Configuration described in [[: | + | It is possible to connect stoplight or fan to controller port P1/P2. Configuration described in [[: |
Please note that controller outputs are open-drain 5V max, 220R resistor on the line. Don't use controller logic ground for loads more than 0.5A, use power ground instead. System (CAN) cable uses power ground. | Please note that controller outputs are open-drain 5V max, 220R resistor on the line. Don't use controller logic ground for loads more than 0.5A, use power ground instead. System (CAN) cable uses power ground. | ||