meta data for this page
Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
en:controller:setup [2022/04/06 12:24] vasilisk [Motor setup] |
en:controller:setup [2022/04/06 12:24] vasilisk [Firmware update] |
||
---|---|---|---|
Line 112: | Line 112: | ||
If an error occurs during autotuning, see the section **[[en: | If an error occurs during autotuning, see the section **[[en: | ||
- | ===== Firmware update ===== | ||
- | |||
- | In the menu section **Controller** > **Update and Settings**, you can update the Controller' | ||
- | |||
- | {{: | ||
- | |||
- | **Import config.** — loads the settings from the file ** NCconf.cfg ** - ** NCconf9.cfg ** up to a maximum of 9 different configurations, | ||
- | **Export config.** - saves the settings to the ** NCconf.cfg ** - ** NCconf9.cfg ** file up to a maximum of 9 different configurations, | ||
- | **Reboot** — restarts the device. If the settings have not been saved, they will be reset.\\ \\ | ||
- | **Reset Wh usage** — resets the accumulated number of Watt-Hours in the controller. This indicator is displayed in the statistics of the On-board computer, see section **[[en: | ||
- | **Reset stats** — resets mileage in kilometers.\\ \\ | ||
- | **Load defaults** — after a reset, the default settings are loaded but not saved. If you restart the Controller without saving after a reset, the previous settings will be loaded.\\ \\ | ||
- | **Erase data storage** — This function may be needed for the correct firmware update, rollback to default settings, in a situation where user actions lead to incorrect operation of the Controller. If the controller has stopped saving the settings, do a reset, wait 3 seconds, and try to save again.\\ \\ | ||
- | **Update firmware** — starting the firmware update process. You can download the current firmware version and read the rules of update in the **[[en: | ||
===== Control modes ===== | ===== Control modes ===== |