meta data for this page
  •  

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Last revision Both sides next revision
en:controller:setup [2023/12/11 14:03]
vasilisk 		en:controller:setup [2024/03/27 10:13]
dmitry [Throttle control mode setup]
Line 334: Line 334:
 {{:en:controller:6_0.8.png?nolink&  }} {{:en:controller:6_0.8.png?nolink&  }}
  
-Three throttle modes options are available: \\ **Speed**  — a similar mode is used in Infineon controllers and non-programmable low-cost controllers and is characterized by the use of maximum current to reach a given speed. In this mode, the maximum thrust is used until the desired speed is reached, the thrust is not regulated by the throttle grip. \\ **Speed+torque**  — combined mode (as Kelly), similar to the operation of the gas pedal in a car with an internal combustion engine. In the case of selecting the **Speed+torque**  mode, pressing throttle to 50%, when achieved 50% speed, the current consumption will be reduced to hold speed. The acceleration current will also be proportionally lower. \\ **Torque**  — in this mode, the throttle controls phase current, the thrust is limited by the angle of rotation of the throttle. \\ **Power+torque**  — In this mode, it is possible to drive an ebike like a motorcycle with an internal combustion engine. The response is similar to the throttle grip on internal combustion engines. \\ **Power**  — in this mode, you can fine-tune the consumption from the battery using the throttle.+Five throttle modes options are available: \\ **Speed**  — a similar mode is used in Infineon controllers and non-programmable low-cost controllers and is characterized by the use of maximum current to reach a given speed. In this mode, the maximum thrust is used until the desired speed is reached, the thrust is not regulated by the throttle grip. \\ **Speed+torque**  — combined mode (as Kelly), similar to the operation of the gas pedal in a car with an internal combustion engine. In the case of selecting the **Speed+torque**  mode, pressing throttle to 50%, when achieved 50% speed, the current consumption will be reduced to hold speed. The acceleration current will also be proportionally lower. \\ **Torque**  — in this mode, the throttle controls phase current, the thrust is limited by the angle of rotation of the throttle. \\ **Power+torque**  — In this mode, it is possible to drive an ebike like a motorcycle with an internal combustion engine. The response is similar to the throttle grip on internal combustion engines. \\ **Power**  — in this mode, you can fine-tune the consumption from the battery using the throttle.
  
 **Adaptive throttle**  — this function allows you to more accurately dose throttle at high speed when the battery current in the settings is several times lower than the phase current. The default is set to 6%. **Adaptive throttle**  — this function allows you to more accurately dose throttle at high speed when the battery current in the settings is several times lower than the phase current. The default is set to 6%.