meta data for this page
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
en:firmware [2022/01/06 14:54] dmitry [30 December 2021] |
en:firmware [2022/01/06 14:55] dmitry [30 December 2021] |
||
|---|---|---|---|
| Line 32: | Line 32: | ||
| </ | </ | ||
| \\ | \\ | ||
| - | |||
| - | |||
| - | |||
| - | |||
| ===== 18 October 2021 ===== | ===== 18 October 2021 ===== | ||
| First need to update all devices but display. Because menu protocol is new and old devices will not be visible in menu. After update finished hold left button few seconds to exit updated device menu. If button does not work you may need to reset power supply or replug CAN cable in display. \\ After everything updated - update display. \\ Make a controller reset (load defaults) after update. \\ I recommend to run motor detect again on controllers. \\ Detection of throttle/ | First need to update all devices but display. Because menu protocol is new and old devices will not be visible in menu. After update finished hold left button few seconds to exit updated device menu. If button does not work you may need to reset power supply or replug CAN cable in display. \\ After everything updated - update display. \\ Make a controller reset (load defaults) after update. \\ I recommend to run motor detect again on controllers. \\ Detection of throttle/ | ||