meta data for this page
Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
en:firmware [2022/01/06 14:54] dmitry [30 December 2021] |
en:firmware [2022/01/20 16:13] dmitry [30 December 2021] |
||
---|---|---|---|
Line 16: | Line 16: | ||
The list of actual firmware to be downloaded: \\ | The list of actual firmware to be downloaded: \\ | ||
+ | ===== 20 January 2022 ===== | ||
+ | |||
+ | Export config before the update, load defaults after the update, and import your config. \\ | ||
+ | |||
+ | **Controller v0.8.5** [[https:// | ||
+ | |||
+ | < | ||
+ | |||
+ | Fixed P1 P2 PWM mode.\\ | ||
+ | Lifetime temperature now calculates only when motor powered.\\ | ||
+ | Added hall pullup disable option.\\ | ||
+ | Various save system fixes.\\ | ||
+ | Fixed NaN for resistance detection.\\ | ||
+ | Fixed import of 1st parameter in every section.\\ | ||
+ | </ | ||
+ | \\ | ||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
===== 30 December 2021 ===== | ===== 30 December 2021 ===== | ||
Critical update for new controllers and hotfix for controllers 6F/12F and old 24F. \\ | Critical update for new controllers and hotfix for controllers 6F/12F and old 24F. \\ | ||
Line 32: | Line 55: | ||
</ | </ | ||
\\ | \\ | ||
- | |||
- | |||
- | |||
- | |||
===== 18 October 2021 ===== | ===== 18 October 2021 ===== | ||
First need to update all devices but display. Because menu protocol is new and old devices will not be visible in menu. After update finished hold left button few seconds to exit updated device menu. If button does not work you may need to reset power supply or replug CAN cable in display. \\ After everything updated - update display. \\ Make a controller reset (load defaults) after update. \\ I recommend to run motor detect again on controllers. \\ Detection of throttle/ | First need to update all devices but display. Because menu protocol is new and old devices will not be visible in menu. After update finished hold left button few seconds to exit updated device menu. If button does not work you may need to reset power supply or replug CAN cable in display. \\ After everything updated - update display. \\ Make a controller reset (load defaults) after update. \\ I recommend to run motor detect again on controllers. \\ Detection of throttle/ |