meta data for this page
  •  

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision 		Previous revision
Next revision Both sides next revision
en:ulight [2021/08/19 09:50]
dmitry [Input values] 		en:ulight [2021/08/26 12:12]
dmitry [Connecting and set up the headlight]
Line 105: Line 105:
 ==== Input values ==== ==== Input values ====
 In this section of the menu you can see the values of the indicators at each input of the uLight board. This menu is similar to the **Debug information**  item in the Controller menu. \\  \\ {{:en:inputs.png?nolink&  }} In this section of the menu you can see the values of the indicators at each input of the uLight board. This menu is similar to the **Debug information**  item in the Controller menu. \\  \\ {{:en:inputs.png?nolink&  }}
- 
 **Current**  — current consumption of headlights, Amperes (**A**). \\  **Current**  — current consumption of headlights, Amperes (**A**). \\ 
 **Voltage**  — supply voltage of the uLight board, Volts (**V**). \\  **Voltage**  — supply voltage of the uLight board, Volts (**V**). \\ 
Line 212: Line 211:
  
 Then return to the main menu, go to the **Save settings**  section and select **On**  to save the settings. Done. We check the operation of the low and high beam headlights by turning on the switch buttons. Then return to the main menu, go to the **Save settings**  section and select **On**  to save the settings. Done. We check the operation of the low and high beam headlights by turning on the switch buttons.
 +~~CL~~ \\
  
 ==== Brake light setup ==== ==== Brake light setup ====