meta data for this page
  •  

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision 		Previous revision
Next revision Both sides next revision
en:ulight [2021/08/19 09:50]
dmitry [Input values] 		en:ulight [2022/04/07 18:41]
dmitry [Function setup]
Line 64: Line 64:
  
 **# Turn signals setup #** \\ **# Turn signals setup #** \\
-Settings for the left and right turn signals. Read more about the setup below in the section **Turn signals setup**. \\ **Left turn switch**  — setting for the left turn signal button. \\ **Right turn switch**  — setting for the left turn signal button. \\ **Warning switch**  — setting for the hazard warning light switch. \\ **Turn brightness**  — select the brightness of the turn signals from 0% to 100% in 5% steps. \\ **Time on-time**  — the speed of turning on the turn signals, together with setting the off time, allows you to control the speed of blinking of the turn signals. Values ​​from 0.1 sec to 1 sec, in 0.1-sec increments. \\ **Turn off-time**  — turn off speed. Values ​​from 0.1 sec to 1 sec, in 0.1-sec increments.+Settings for the left and right turn signals. Read more about the setup below in the section **Turn signals setup**. \\ **Left turn switch**  — setting for the left turn signal button. \\ **Right turn switch**  — setting for the left turn signal button. \\ **Warning switch**  — setting for the hazard warning light switch. \\ **Turn brightness**  — select the brightness of the turn signals from 0% to 100% in 5% steps. \\ **Time on-time**  — the speed of turning on the turn signals, together with setting the off time, allows you to control the speed of blinking of the turn signals. Values ​​from 0.1 sec to 1 sec, in 0.1-sec increments. \\ **Turn off-time**  — turn off speed. Values ​​from 0.0 sec to 1 sec, in 0.1-sec increments. Setting the value to 0.0 sec will disable the blinking function of the turn signals.
  
 **# Brake signal setup #** \\ **# Brake signal setup #** \\
Line 211: Line 211:
  
 Then return to the main menu, go to the **Save settings**  section and select **On**  to save the settings. Done. We check the operation of the low and high beam headlights by turning on the switch buttons. Then return to the main menu, go to the **Save settings**  section and select **On**  to save the settings. Done. We check the operation of the low and high beam headlights by turning on the switch buttons.
 +~~CL~~ \\
  
 ==== Brake light setup ==== ==== Brake light setup ====