meta data for this page
Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
en:ulight [2022/04/18 10:05] dmitry [Inputs configuration] |
en:ulight [2022/04/18 10:10] dmitry [Inputs configuration] |
||
---|---|---|---|
Line 59: | Line 59: | ||
**T-sensor T1 type** — selection of **NTC10K3950** | **T-sensor T1 type** — selection of **NTC10K3950** | ||
**# T-sensor T1** — current temperature of the thermal sensor Т1 in degrees Celsius (°C). \\ | **# T-sensor T1** — current temperature of the thermal sensor Т1 in degrees Celsius (°C). \\ | ||
- | **T1 Threshold (port I7)** — I7 is a virtual port intended to function setup (see Function setup). | + | **T1 Threshold (port I7)** — I7 is a virtual port intended to function setup (see Function setup). |
- | **T-sensor T1** — displays the temperature of the temperature sensor | + | **Т1 Threshold mode** — signal operation mode from the temperature sensor, selection of values **Normal** (the signal state is first “off” when triggered is “on”) and **Inverted** (the signal state is first “on”, when triggered is “off”). \\ |
- | **T-sensor T2 type** — similar to the **T-sensor T1 type** | + | The settings for Temperature |
- | **T-sensor T2** — similar to the settings | + | **CAN-Control** — this setting refers to the **THR** |
- | **CAN-Control** — this setting refers to the **THR** | + | **CAN ports** — redirecting inputs to groups of CAN ports for controlling the controller. Choice of OFF, CAN 1-8 and CAN 9-16. |
==== Function setup ==== | ==== Function setup ==== |