meta data for this page
Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
en:ulight [2022/04/18 10:05] dmitry [Inputs configuration] |
en:ulight [2022/04/18 10:15] dmitry [Function setup] |
||
---|---|---|---|
Line 54: | Line 54: | ||
~~CL~~ \\ | ~~CL~~ \\ | ||
==== Inputs configuration ==== | ==== Inputs configuration ==== | ||
- | The functions of inputs **I1-I6 ** (see diagram above) are selected in the **Function setup** | + | The functions of inputs **I1-I6 ** (see diagram above) are selected in the **Function setup** |
| | ||
{{: | {{: | ||
- | **T-sensor T1 type** — selection of **NTC10K3950** | + | **T-sensor T1 type** — selection of **NTC10K3950** |
**# T-sensor T1** — current temperature of the thermal sensor Т1 in degrees Celsius (°C). \\ | **# T-sensor T1** — current temperature of the thermal sensor Т1 in degrees Celsius (°C). \\ | ||
- | **T1 Threshold (port I7)** — I7 is a virtual port intended to function setup (see Function setup). | + | **T1 Threshold (port I7)** — I7 is a virtual port intended to function setup (see Function setup). |
- | **T-sensor T1** — displays the temperature of the temperature | + | **Т1 Threshold mode** — signal operation mode from the thermal |
- | **T-sensor T2 type** — similar to the **T-sensor T1 type** | + | The settings for Temperature |
- | **T-sensor T2** — similar to the settings | + | **CAN-Control** — this setting refers to the **THR** |
- | **CAN-Control** — this setting refers to the **THR** | + | **CAN ports** — redirecting inputs to groups of CAN ports for controlling the controller. Selectable values — **OFF**, **CAN 1-8** and **CAN 9-16**. |
==== Function setup ==== | ==== Function setup ==== | ||
- | Function setup allows you to select which function each input on the uLight board or CAN input in the Controller or On-board computer corresponds to. All settings in this section of the menu have the same selection of functions: \\ **Off **— disabled. \\ **On** | + | Function setup allows you to select which function each input on the uLight board or CAN input in the Controller or On-board computer corresponds to. All settings in this section of the menu have the same selection of functions: \\ |
+ | **Off **— disabled. \\ | ||
+ | **On** | ||
+ | **I1-I6** | ||
+ | **I7_T1** and **I8_T2** — selection of the virtual port of the temperature sensor **T1** and **T2**. \\ | ||
+ | **C1-C16** | ||
{{: | {{: |